Your Reading List

Tuck it in right

Preparing equipment for cold winter conditions will pay dividends in reduced maintenance requirements over the long run

Preparing equipment for cold winter conditions will pay dividends in reduced maintenance requirements over the long run

Now that most field operations have finished for the season and the first snow storm has hit the prairie, it’s time for farmers to think about end-of-season maintenance procedures before tucking those big machines into a storage shed for the winter.

AGCO has some tips on just what should be done to ensure machines are parked up for the season in the proper condition. To help farmers remember how to winterize their equipment, the brand is introducing a concept it calls FARMS, an acronym that helps producers remember everything that needs to be done to prepare equipment for winter storage.

FARMS consists of five steps farmers should take to protect their equipment investment and prepare for next spring: fill tanks, adequately lubricate, repair damage, maintain and clean and store equipment.

“FARMS is a simple way to remember the important steps that go into winterizing equipment,” says Keith Dvorak, AGCO product performance manager. “It’s one of the easiest and most affordable ways to extend the life of equipment, adding more return on that initial big-ticket investment.”

The five steps of FARMS to effectively protect equipment until next spring include:

  • Fill Tanks – Condensation can occur as the weather changes from cool to warm, and can cause water to enter empty tanks, causing costly damage. Top off both the fuel and the hydraulic oil tanks to eliminate condensation. Store diesel exhaust fuel (DEF) in its original container during the winter. Be sure the tank vent is plugged and keep the container away from any heat and direct sunlight.Adequately Lubricate – One of the most effective ways to protect equipment is to make sure it is lubricated well. Refer to the operator instruction book and lubricate as indicated. Grease unpainted metal parts, such as hydraulic cylinder rods, to protect them from the elements.
  • Repair Damage – Harvest takes its toll on farmers and equipment alike. Be sure to fix any damage that occurred during the year. This will ensure that broken parts don’t worsen or rust during the winter, and will allow immediate access to the equipment when it is needed next spring or summer.
  • Maintain and Clean – At the end of harvest, be sure to remove dust and debris from inside and outside of the equipment. Conduct regular maintenance, such as changing the oil and fluids, and checking air pressure in the tires. Protect the air inlet and exhaust from humidity. Lower each linkage fully to avoid pressure buildup in the hydraulic rams, and if possible, slacken the engine accessories’ belt tensioner. Finally, if preferred, remove the battery and store in a dry location.
  • Store Equipment – Obviously, the best way to protect equipment is under a roof. However, that is not possible for every farmer. Cover the equipment if left outdoors, and protect computerized mechanisms from sun damage by covering with a cloth. For extra protection, use water-resistant products such as wax to help keep equipment from rusting and causing premature wear.
  • Hay equipment requires some additional steps to effectively winterize it, but the additional steps will help maintain the value of the equipment. To winterize hay equipment, AGCO recommends draining any preservatives housed in the baler; remove tension on round balers’ forming belts and remove the fire extinguisher (water variety) from square balers and store properly.

“At AGCO, we believe in helping farmers protect their investment in equipment, regardless of brand,” concludes Dvorak. “Farmers work hard all year-round, and they need equipment that will help them complete their daily tasks. By taking just a small amount of time this winter to make sure tractors and hay equipment are properly stored, farmers can rely on them for many growing seasons to come.”

 

Scott

 

About the author

Contributor

Scott Garvey

Scott Garvey is a freelance writer and video producer. He is also the former machinery editor at Grainews.

Comments

explore

Stories from our other publications